Using the new Push To Pass system
Push to pass goes into its own HDV section, called [PUSH2PASS].
| Parameter | Description | Example |
|---|---|---|
| Push2PassType | Specifies which mode you want to use, 0 for EngineMap, 1 for BoostMap | Push2PassType=1 |
| Push2PassEngineMap | Specifies which engine map to use for the system. | Push2PassEngineMap=4 |
| Push2PassBoostMap | Specifies which boost map to use for the system. | Push2PassBoostMap=2 |
| Push2PassMaxTime | Sets the maximum amount of time the system can be used in a session. Only really affects race sessions | Push2PassMaxTime=120 |
| Push2PassTimePerPush | Sets a time limit per activation | Push2PassTimePerPush=15 |
| Push2PassHoldButton | Make it so the push2pass button must be held for the system to work | Push2PassHoldButton=1 |
| Push2PassMaxUses | Allows you to limit the amount of uses in a race, use -1 if you want unlimited(limited by MaxTime only) | Push2PassMaxUses=54 |
| Push2PassAllowManualDeactivation | Allows for toggling the system, for example, Indycar can turn it on and off, but BTCC cannot | Push2PassAllowManualDeactivation=1 |
| Push2PassActivateThrottleThreshold | Throttle position for activating the system, use from 0 to 1, recommended: 0.6 | Push2PassActivateThrottleThreshold=0.1 |
| Push2PassDeactivateThrottleThreshold | Throttle position for deactivating the system, use from 0 to 1, recommended: 0.5 | Push2PassDeactivateThrottleThreshold=0.4 |
| Push2PassMinStartSpeedKPH | Sets a speed in which you must meet to enable the system in kph, for example, BTCC uses 110 | Push2PassMinStartSpeedKPH=124 |
| Push2PassActivationsPerLap | Limits the amount of uses per lap, default is 0 | Push2PassActivationsPerLap=5 |
| Push2PassInPractice | If the system is enabled in the session, default is 0 | Push2PassInPractice=0 |
| Push2PassInQuali | If the system is enabled in the session, default is 0 | Push2PassInQuali=1 |
| Push2PassInWarmup | If the system is enabled in the session, default is 0 | Push2PassInWarmup=0 |
| Push2PassInRace | If the system is enabled in the session, default is 0 | Push2PassInRace=1 |